Fractal 75 – Frame Kit
Remaining true to its original intent, the Fractal 75 features:
75mm diagonal, squished X geometry, for 40mm props
1.5mm Carbon Fiber / Individual Nylon ducts hybrid construction. Cut from Japanese T300 CF sheet
Low-profile camera mount, no props in view, no tilt offset
Low Center of Gravity, by bringing the AIO closer to the frame/motors
Allows mounting with USB pointing up for easy accelerometer calibration
No need for a canopy as all electronics are tucked safely between the ducts
Maximum rigidity where it matters most; connecting the motors to the FC
Easy maintenance, break one duct, replace only the single duct
Lightweight, about 21g with HM DiamondF4
As always, this is a project that I designed for myself first, that I put together in a product to share with any pilot that would like to experience the same level of requirements!
Designed with love, by a pilot, for pilots.
But don’t take my word for it, here’s what Team Pilot Glenn “Bellaciao” has to say about it:
“Tank like. Can slam it into the ground and it’s fine. Haven’t had any delamination or build quality issues. There’s plenty of room to add a vtx and rx, the ducts protects the parts from impact, and with 2s it truly feels like a larger quad. Facepunches will hurt.”
Or a few notes from Sushan “Brdsrtrl”
“Very stable and predictable, Makes an easy platform to make a super reliable quad, a million different configurations, Makes it easy to tuck away external parts if you aren’t using an aio.”
What do you get?
This frame kit contains everything you need to build your own craft, based on virtually any components.
I do however recommend a 4-1 AIO (FC/ESC/RX/VTX) to keep the part count to a minimum, but there should be enough room to stack a separate VTX or RX on top of the AIO
It has a 25.5×25.5mm mounting pattern for the AIO, and motor fixations for both 3xM1.4×6.6mm and 3xM1.6×5.5mm
The camera mount is 3D printed and universal – I will upload the STL and Step files so you may print your own spares or season them to taste
Contents:
1x Fractal 75, 1.5mm thick Base Plate
1x Nylon frame (used by trimming the ducts off)
2x Printed TPU fixations – 1x 300mah and 1x 450mah 1S (camera, front and rear battery mounts)
13x M1.4x5mm steel machine screw for motors
4x M1.7x5mm self-threading screw for short board grommets
4x M1.7x7mm self-threading screw for long board grommets
Notes:
1-Only the frame kit is included. Full build pictures for reference only.2-Due to continually ongoing development the actual product may differ from pictures.
